Categories

ACCELEROMETERS, GYROS & COMPASSES

ACCELEROMETERS, GYROS & COMPASSES
Sort By:
Show:
  • Multiwii Compass Module HMC5883L
    Multiwii Compass Module HMC5883L HMC5883L is a 3-axis digital compass from Honeywell. Communication with the HMC5883L is simple and all done through an I2C interface. There is no on-board regulator, so a regulated voltage of 2.16-3.6VDC should be supplied.   This breadboard-friendly board breaks out pins  to a 4-pin 0.1" pitch header and it also has two 10k pull-up resistors on the I2C lines. Features: Simple I2C interface 2.16-3.6VDC supply range Low current draw 5 milli-gauss resolution Dimensions: 15.2x15.2 mm ..
    S$28.00
  • ADXL335 3V-5V Triaxial Accelerometer Analog Output
    Name: ADXL335 module (triaxial accelerometer analog output) Model: GY-61 Using the chip: ADXL335 Power supply :3-5v Analog X, Y, Z three-axis output Direct output angle code ..
    S$6.60
  • AltIMU-10 v5 Gyro, Accelerometer, Compass, and Altimeter (LSM6DS33, LIS3MDL, and LPS25H Carrier)
    AltIMU-10 v5 Gyro, Accelerometer, Compass, and Altimeter (LSM6DS33, LIS3MDL, and LPS25H Carrier) The Pololu AltIMU-10 v5 is an inertial measurement unit (IMU) and altimeter that features the same LSM6DS33 gyro and accelerometer and LIS3MDL magnetometer as the MinIMU-9 v5, and adds an LPS25H digital barometer. An I²C interface accesses ten independent pressure, rotation, acceleration, and magnetic measurements that can be used to calculate the sensor’s altitude and absolute orientation. The board operates from 2.5 to 5.5 V and has a 0.1″ pin spacing.   Dimensions Size: 1.0″ × 0.5″ × 0.1″1 Weight: 0.8 g1 General specifications Interface: I²C Minim..
    S$36.90
  • navX-MXP Robotics Navigation Sensor
    navX-MXP Robotics Navigation Sensor     •    9-Axis Sensor (Gyro / Accelerometer / Magnetometer) •    Intelligent Motion Processor •    RoboRIO Expansion I/O Supercharge your robot:  Field-oriented drive, auto-balancing, collision detection, motion detection, auto-rotate-to-angle, and more… Expand your RoboRIO:  10 Digital I/Os, 4 Analog Inputs, 2 Analog Outputs, and TTL UART / I2C / SPI ports. Plug-n-Play:  easily installed via RoboRIO’s MXP Expansion connector or USB port. Open Source:  firmware source code, board schematics/layout & bill of materials available online. Easy-to-integrate:  C++, Java and LabView libraries and sample application code simplify inte..
    S$299.00