ADAPTER BOARD FOR ARDUINO & RASPBERRY PI

ADAPTER BOARD FOR ARDUINO & RASPBERRY PI

Arduino is a massive ecosystem, if there's a way for the Raspberry Pi GPIO interface to adapt to Arduino pinouts,
it is possible to use the Pi together with vast Arduino shields and hardware/software resources. The ARPI600 is
just intended for this.

What's more, the ARPI600 also support XBee modules, make it easy to add wireless feature to your great project.

ARPI600 Features

• Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
• Compatible with Arduino UNO, Leonardo, easy to connect with various Arduino shields
• XBee connector for connecting various XBee modules
• Sensor interface for connecting various sensors
• Onboard USB TO UART for serial port debugging, also can be configured as XBee USB adapter
• Onboard ADC, 10 bit, 38KSPS, 11 channels (6 channels for Arduino interface, 5 channels for sensors)
• Onboard RTC
  
  
   
• Arduino connector : for connecting Arduino shields
• ICSP interface : Arduino ICSP
• XBee connector : for connecting XBee communication modules
• Sensor interface : for connecting sensors
• Raspberry Pi connector : for connecting Raspberry Pi
• USB TO UART
• TLC1543 : AD converter
• PCF8563 : RTC
• CP2102
• 32.768KHz crystal : for RTC
• Power indicator
• XBee state LED
• XBee and Arduino interface RESET button
• XBee EASYLINK button
• RTC battery holder : for CR1220 button battery
• TLC1543 reference voltage configuration jumper
• RTC jumper
• UART jumper
  • when connecting P_RX and CP_TX, P_TX and CP_RX respectively, USB TO UART is connected to Raspberry Pi serial port
  • when connecting XB_RX and CP_TX, XB_TX and CP_RX respectively, USB TO UART is connected to XBee serial port
  • when connecting XB_RX and P_TX, XB_TX and P_RX respectively, Raspberry Pi serial port is connected to XBee serial port
• Arduino AD selection jumper
  • short 2 and 3 : Arduino A0-A5 as AD input
  • short 1 and 2 : Arduino A0-A5 as digital control
• Arduino I2C selection jumper
  • short the jumper : Arduino A4-A5 as I2C control (the A4-A5 of Arduino AD selection jumper should be opened)
• Arduino SPI selection jumper
  • short 1 and 2 : Arduino D11-D13 as SPI control (default)
  • short 2 and 3 : Arduino D11-D13 as digital control