ELECTRET MICROPHONE AMPLIFIER - MAX4466

ELECTRET MICROPHONE AMPLIFIER - MAX4466

Add an ear to your project with this well-designed electret microphone amplifier. This fully assembled and tested
board comes with a 20-20KHz electret microphone soldered on. For the amplification, we use the Maxim MAX4466,
an op-amp specifically designed for this delicate task! The amplifier has excellent power supply noise rejection, so
this amplifier sounds really good and isn't nearly as noisy or scratchy as other mic amp breakouts we've tried! This
breakout is best used for projects such as voice changers, audio recording/sampling, and audio-reactive projects
that use FFT. On the back, we include a small trimmer pot to adjust the gain. You can set the gain from 25x to 125x.
That's down to be about 200mVpp (for normal speaking volume about 6" away) which is good for attaching to something
that expects 'line level' input without clipping, or up to about 1Vpp, ideal for reading from a microcontroller ADC. The
output is rail-to-rail so if the sounds get loud, the output can go up to 5Vpp!

Using it is simple: connect GND to ground, VCC to 2.4-5VDC. For the best performance, use the "quietest" supply available
(on an Arduino, this would be the 3.3V supply). The audio waveform will come out of the OUT pin. The output will have a
DC bias of VCC/2 so when it's perfectly quiet, the voltage will be a steady VCC/2 volt (it is DC coupled). If the audio
equipment you're using requires AC coupled audio, place a 100uF capacitor between the output pin and the input of your
device. If you're connecting to an audio amplifier that has differential inputs or includes decoupling capacitors, the 100uF
cap is not required.

The output pin is not designed to drive speakers or anything but the smallest in-ear headphones - you'll need an audio
amplifier (such as our 3.7W stereo amp) if you want to connect the amp directly to speakers. If you're connecting to a
microcontroller pin, you don't need an amplifier or decoupling capacitor - connect the OUT pin directly to the microcontroller
ADC pin.