PL2303HX USB TO UART TTL CABLE
-
Product Code:
SG-PL2303HX-C Availability:
30
-
Price:
S$ 9.90
Qty
PL2303HX USB TO UART TTL CABLE
Note: Setting 3.3V and 5.0V output (this is the power to the microcontroller, the need to upgrade the machine)
Please pull out the small plate from the computer, set the jumper to take, do not charge it to avoid damage to
the device. Pin connection and description: Connector pin assignments before you must find, especially GND
must not be connected to the voltage pin, and RX and TX side do not connected to the VCC pin, the (actual
measurement had some VCC pin voltage up to 14V.) Wrong shall be burnt chip adapter cable, be sure to note,
do not take their own small board to do the experiment, otherwise we are not responsible for any burn. We
must find a good pin definitions in the access. Connection method: Again Brush only need three lines, generally
used only RX TX GND three signal lines, VCC no connection. The above is 4,5 needles friends, not to VCC and BT
needle. Please use the RXD and target board TX phase, TXD and target board RX phase, GND connection GND, if
not, were reversed RX and TX.
Connection: RX for TX; TX to RX;
Ground-ground (GND to GND) Black cable-----GND Green cable----TXD White cable----RXD Red cable -----VCC(5V)
Built-in TTL COM PC-PL2303HX Chip Standard USB type A male and TTL 4 pin connector
Cable length: 1000mm (39 3/8 in)
Simple and Easy way to give USB support to your designs Available for Linux, WinCE and Windows (XP, 2003), Vista, Win 7
Tags: PL2303HX USB TO UART TTL CABLE