ADAFRUIT FEATHER HUZZAH WITH ESP8266 - LOOSE HEADERS

ADAFRUIT FEATHER HUZZAH WITH ESP8266 - LOOSE HEADERS

This is the Adafruit Feather HUZZAH ESP8266 - our take on an 'all-in-one' ESP8266 WiFi development board with
built-in USB and battery charging. It's an ESP8266 WiFi module with all the extras you need, ready to rock! 

At the Feather HUZZAH's heart is an ESP8266 WiFi microcontroller clocked at 80 MHz and at 3.3V logic. This
microcontroller contains a Tensilica chip core as well as a full WiFi stack. You can program the microcontroller
using the Arduino IDE for an easy-to-run Internet of Things core. We wired up a high-quality SiLabs CP2104
USB-Serial chip that can upload code at a blistering 921600 baud for fast development time. It also has
auto-reset so no noodling with pins and reset button pressings. The CP2104 has better driver support than the
CH340 and can do very high speeds without stability issues.

To make it easy to use for portable projects, we added a connector for any of our 3.7V Lithium polymer
batteries and built-in battery charging. You don't need a battery, it will run just fine straight from the micro
USB connector. But, if you do have a battery, you can take it on the go, then plug in the USB to recharge. The
Feather will automatically switch over to USB power when it's available.

Here's some handy specs!

• Measures 2.0" x 0.9" x 0.28" (51mm x 23mm x 8mm) without headers soldered in
• Light as a (large?) feather - 6.1 grams
• ESP8266 @ 80MHz with 3.3V logic/power
• 4MB of FLASH (32 MBit)
• Built in WiFi 802.11 b/g/n
• 3.3V regulator with 500mA peak current output
• CP2104 USB-Serial converter onboard with 921600 max baudrate for speedy uploading
• Auto-reset support for getting into bootload mode before firmware upload
• 9 x GPIO pins - can also be used as I2C and SPI
• 1 x analog inputs 1.0V max
• Built-in 100mA LiPoly charger with charging status indicator LED, can also cut a trace to disable the charger
• Pin #0 red LED for general purpose blinking. Pin #2 blue LED for bootloading debug & general purpose blinking
• Power/enable pin
• 4 mounting holes
• Reset button