WD40 SPECIALIST FAST DRYING CONTACT CLEANER 360ML
-
Product Code:
SG - WDCC360 Availability:
5
-
Price:
S$ 13.50
Qty
WD40 SPECIALIST FAST DRYING CONTACT CLEANER 360ML
PERFECT FOR CLEANING ELECTRICAL EQUIPMENT, CONTACTS AND PLASTICS
Cleans away oil, dirt, flux residue and condensation from sensitive electronics and electrical equipment, by rapidly penetrating hard-to-reach areas and dries quickly without leaving any residue
Dielectric strength up to 35,000 Volts per 0.1 inch
Fast-acting, non-conductive cleaner
Penetrates quickly, fast drying and leaves no residue
ROHS Compliance
Isolate all electricity and allow hot surfaces to cool.
Make sure all stored power is drained from the system.
Shake can well before use.
Hold can 15cm to 20cm away from the surface and spray directly onto the electronic device or circuit board to eliminate and remove contaminants that may cause loss of electrical contact.
Tilt surface while cleaning and allow any excess cleaner to run off.
Allow product to dry completely and thoroughly vent the system before restoring power.
Boiling Point (initial) | 60℃ |
Solubility in Water | Insoluble |
Solubility in Water | Insoluble |
Extreme Cleaning Score | 63.4% (ASTM D4488 – A2) |
Dielectric strength | 35,000 volts per 0.1 inch |
Percent Volatile | 100% |
Flash Point | -23℃ |
Specific Gravity | 0.66 |
Appearance/Odor | Clear liquid / hydrocarbon odor |
Tags: WD40 SPECIALIST FAST DRYING CONTACT CLEANER 360ML